Particular hardware related problems with a product (product must be in warranty) can be resolved by replacing parts, which customers can remove and replace by themselves. This process is called Customer Replaceable Unit or CRU. A service part, which can be removed and replaced by a customer, is called Customer Replaceable Unit (CRU) service part. Various levels of difficulty, inidicated with a specific CRU Level ID, are available and located in the service parts list.
The following is a list of the various CRU Level ID types:
CRU Level ID 0 - | Not possible (parts, either not to be replaced by the customer or not installed in the dedicated model) |
CRU Level ID 1 - | Possible for all customers (simple to replace parts, requiring few or no tools) |
CRU Level ID 2 - | Possible for experienced customers (optional parts, which are slightly more difficult to replace) |
CRU Level ID 3 - | Possible for B2B customers with helpdesk (requires trained service personnel) |
When installing a CRU, dynabook will send the CRU to you. CRU information and general replacement instructions are shipped with your product, and are available from dynabook at any time upon request.
Model specific CRU information
Satellite Pro C40-G, C40-H, C40-J series
CRU service part removal and replacement procedure:
This document describes how to perform hardware service maintenance for your Personal Computer. The procedures described in this document are intended to help users to replace faulty Customer Replaceable Units (CRU).
Base Cover Removal
1. ) Remove seven M2.0x7.0x4.5black Phillips head screws securing Base Enclosure and four M2.0x.3.5x4.5black Phillips head screws securing Base Enclosure .
2. ) Remove Base Enclosure.
Installing the memory module
Installing the Base Assy
1.) Place Base Enclosure in correct position.
2.) Secure Base Enclosure with seven M2.0x7.0x4.5black Phillips head screws and M2.0x3.5x4.5black Phillips head screws.
Installing the Battery pack
CAUTION:
The battery packs contain a lithium ion battery, which can explode due to improper replacement, use, handling, or disposal.
Always dispose of the battery packs as required by local ordinances or regulations. Use only replacement batteries recommended by dynabook.
NOTE:
Visually check the battery's terminals. If they are dirty, clean them with a dry cloth.
1.) Take a new or recharged Battery Pack.
2.) Place Battery Pack in correct position.
3.) Secure Battery with four M2.0x3.0x4.5 black Phillips head screws.
4.) Check the battery screw hole ,if there is cracking,please replace the parts.
5.) Connect Battery cable to CN3 on system board.
6.) Installing Battery Maly.
Perform a functional check to see, if the unit is working as expected.
The appendices describe the following:
NOTE
Pictures shown are for illustration purpose only. Actual product may vary due to product enhancement or platfrom generation changes.
DISCLAIMER
Dynabook provides this information "as is" without warranty of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability or fitness for a particular purpose. Dynabook shall not be responsible for the topicality, correctness, completeness or quality of the information or software provided. Dynabook is not liable for any damage caused by the use of any information or software provided, including information that is incomplete or incorrect. Any trademarks used herein belong to their respective owners.
Copyright Dynabook Europe GmbH. All rights reserved.